![]() ![]() Occurs independently on Layer 2 and Layer 3 interfaces. Layer 2 and Layer 3 interfaces at the same time, traffic forwarding Secure wire can coexist with Layer 3 mode. Only if the traffic is permitted by a security policy. Wire interface forwards all arriving traffic to the peer interface That the two interfaces of a secure wire must ideally be directlyĬonnected to Layer 3 entities, such as routers or hosts. SRX Series Firewalls that provide point-to-point connections. Secure wire is a special case of Layer 2 transparent mode on Secure wire supports Layer 7 features like AppSecure, SSL proxy, Not supported in transparent mode, including NAT and IPsec VPN. This feature does not support security features Secure wire supports chassis cluster redundantĮthernet interfaces. You can configure interfacesįor access or trunk mode. This feature is available on Ethernet logical interfaces only īoth IPv4 and IPv6 traffic are supported. Must be bound to security zones and a security policy configured to Logical interfaces must be configured with family ethernet-switching and each pair of interfaces must belong to the VLAN(s). ![]() Level two Ethernet logical interfaces must be specified. Secure wire mapping is configured with the secure-wire statement at the hierarchy Unchanged out of the other peer interface. Policy, a packet arriving on one peer interface is immediately forwarded As long as the traffic is permitted by a security It differs from transparentĪnd route modes in that there is no switching or routing lookup toįorward traffic. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |